WANHAO Duplicator 4x Manual do Utilizador descarregar pdf (Página 28)

Startup process: leveling, loading , testing

---------------------------------------------------------------------------------------------------------------------------------------

--------

LEVELING THE BUILD PLATE

--------------------------------------------------------------------------------------------------------------------------------------------

5. Push the Filament into the Extruder

To use one hand to push the loading

button down and Take the end of the PLA

Filament closest to the extruder and firmly

push it into the hole in the top of the

extruder.Ensure that the filament goes

into the center of the opening and doesn

’

get caught at the edge of the opening.

Maintain pressure on the filament and

continue pushing it into the opening.

After about five seconds, you should

begin to feel the motor pulling in the

filament. Maintain pressure for another

five seconds and then let go.

6. Stop Extrusion

Watch the extruder nozzle. After a few

moments, you should see a thin string of

the PLA Filament that you loaded come

out of the nozzle. Press the OK button to

stop extrusion.

NOTE: Don’t be surprised if the

filament that initially comes out of the

nozzle is not the color you expected.

There’s probably some filament inside

the extruder left over from our testing

process in factory. Wait until you see the

color that you loaded come out of the

nozzle before you press the OK button.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 72 73

Sem comentários

WANHAO Duplicator 4x Manual do Utilizador Página 28